roduct Details
NEUSPEED Power Modules ship to your door and install on your own time. No need to rent complicated devices or drive your vehicle long distances to tune your vehicle. This device can be installed by any individual within an hour with the supplied, easy-to-read instructions and net you up to 40+ HP on 100 Octane fuel.
1.8 TSI: 30+ HP / 55+ ft./lbs.Torque
2.0 TSI: 35+ HP / 70+ ft/lbs.Torque
2.0 TSI "Budack/Miller Cycle": 30+ HP / 55+ ft./lbs.Torque
Increases boost by modifying the charge pressure and map sensor readings
Allows ECU to remain in control of boost
The actual boost is increased by a precise amount
Boost is increased in a gradual, progressive fashion
Uses the closed loop control of the ECU to increase boost
Readings in the vacuum region are stock
No effect on cold start
No effect on warm-up
No change to idle, cruise and moderate acceleration modes of operation
Retains stock ECU programming
No change to factory ECU programming, communication or safety protocols
No ECU TD1 code to void manufactures warranty
Not effected by ECU reprogramming by the dealer
Makes use of existing ECU programming for higher boost levels
Correct Air/Fuel mixture maintained from the wide band O2 and closed loop mode of the ECU
Ignition timing optimized by the ECU
Easy Installation
Plug-and-play intercept at Boost and MAP sensor connector locations
Installation or removal can be completed in a few minutes
No trace Power Module was ever there after removal
Power Module can be sold or installed on another vehicle of the same engine type.
*Pending CARB Compliance
****NOTE: DO NOT USE POWER MODULE IF ECU HAS BEEN TUNED OR MODIFIED****